[SunHELP] SKG 9822 dual port card does not work

aalinaser at cox.net aalinaser at cox.net
Fri Dec 30 14:02:15 CST 2005

Hello All,

Hello ,

I have just installed Solaris 9 on a Sunblade 100 (Sparc) workstation. I have  also installed SysKonnect SKGE 9822 dual port card as well.  Please note the output of different commands to show you how it is configured. I cant figure out that why it is not working? All the configuration looks alright. Is there something extra or special I need to do to make it work under Solaris 9. The same card worked fine on the same server with Solaris 8.
Any help from you to resolve this will be greatly appreciated.

netstat -rn

Routing Table: IPv4
  Destination           Gateway           Flags  Ref   Use   Interface
-------------------- -------------------- ----- ----- ------ ---------             U         1      7  eri0             U         1      0  skge0              UG        1      0             U         1      0  eri0
default                UG        1      0              UH       19   1900  lo0

ifconfig -a
lo0: flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4> mtu 8232 index 1
        inet netmask ff000000
eri0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
        inet netmask ffffff00 broadcast
        ether 0:3:ba:b:5b:e6
skge0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 3
        inet netmask ffffff00 broadcast
        ether 0:0:5a:9c:85:8

modinfo | grep -i skg
104 78056000  504f3 270   1  skge (SysKonnect SKGEsolx driver 8.12)


More information about the SunHELP mailing list