[rescue] sunpci II software

Richard ejb at trick-1.net
Mon May 18 05:35:41 CDT 2020


I brought a couple of these cards up just recently. When I asked the super
helpful folks on the list this is what I got so I thought I would pay it on

http://www.neurotica.com/misc/SunPCi/ <http://www.neurotica.com/misc/SunPCi/>

Manual and other useful information


Supported Systems and Power Requirements
The SunPCi II card is a 33/66-MHz PCI card that draws 25 Watts (DC) of power.
You can install the card into any standard 33- or 66-MHz PCI slot on one of
the UltraSPARC systems listed in table 1-1

I ended up getting 3 cards working in a Netra T1125. I have since gone back
2 cards because I wanted a 1Gig Nic :-). The Software allows you to bring up
the console in an Openwindows window

Hope that helps


> On 18 May 2020, at 6:47 pm, Peter Stokes <peter at ashlyn.co.uk> wrote:
> Hi
> I am sure someone here will come along and have a link to it online, but if
> not I can go look for it as I used it many moons ago. From memory only
> versions of Solaris were supported, but I think it was possible to get it
> working under 10?
> Peter
> Sent from my iPad
>> On 18 May 2020, at 09:44, silvercreekvalley <silvercreekvalley at yahoo.com>
> wrote:
>> o;?I have a Sun PC II card installed in my Ultra 10 and as it makes a fair
> old
>> noise with the fan, I thought it would be good to get it working.
>> Does anyone know where you can find the software for this? The card
>> fine, but doesnbt output anything on the graphics port, so assume it
>> drives for disk access, etc.
>> _______________________________________________
>> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue

More information about the rescue mailing list