[rescue] SCSI solutions for Sparcstation Voyager

systems_glitch systems.glitch at gmail.com
Mon Nov 19 17:44:41 CST 2018

OpenBSD-CURRENT does that on SPARC64, I've got a CP1500 deployed where
it'll blink the READY LED related to loadavg.


On Mon, Nov 19, 2018 at 5:58 PM Ron Wickersham <rjw at alembic.com> wrote:

> On Mon, 19 Nov 2018, Steve Hatle wrote:
> ---snip---
> > One thing, though... the LED on the front of the machine is flashing
> while
> > it's running. I can't find any doc that say why that might be, except a
> note
> > in the service manual that says that LED will be lit if "the machine is
> > running normally". All the diags pass as best I can tell, and as I say
> the
> > machine runs fine, so it's an annoyance more than anything else. I need
> to dig
> > to find my Field Engineer's Guide, but thought perhaps the collective
> might
> > have an insight.
> check the man page for "led".  in a sparc classic i had the led blinked to
> identify that it was running OpenBSD, long ago with an earlier release of
> the operating system.    the current man page says sysctl(2) variable
> "machdep.led_blink" now blinks based on the load average on most systems
> by setting this parameter to a non-zero value.
> -ron
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue

More information about the rescue mailing list