[rescue] Multipack Power Supply pin-out?
jpstewart at sympatico.ca
Wed Aug 23 10:27:47 CDT 2017
On 23/08/17 06:16 AM, Jonathan Katz wrote:
> I'm repurposing an old 1st gen Multipack as a case/setup for a cluster
> of Raspberry Pi systems. I'd like to reuse the Multipack's power
> supply to power the Pis & an ethernet switch I wish to mount inside.
> To do this I need the pinout of the power supply. Does anyone have
> this? Worst case I can break out a multimeter, but I figure someone
> may have this.
> This is the original Sun doc on the product, so there isn't much confusion.
According to section 7.1 of that document, the power supply part number
is 300-1330. Pinouts for that can be found on-line in the Field
More information about the rescue