[rescue] bracket for sun f20 card?
francois.dion at gmail.com
Thu Dec 22 11:15:47 CST 2016
f20 has no external connectors. There are some vent holes and LED holes
(although they do not reach, the LEDs are recessed. I tried an Intel dual
gig card that was half height but with full height bracket, with just the
bottom screw in place (so I didn't have to drill) but unfortunately, the
edge connector barely sits on top of the pcie slot.
Now why didn't I think of using a blank slot cover... just need to make two
little L brackets to attach it... Yep, going to try that.
Maybe combine Romain's suggestion and just print the two little brackets to
connect the two pieces together. :)
On Thu, Dec 22, 2016 at 11:59 AM, Nick B <nick at pelagiris.org> wrote:
> As long as you don't have any external connectors, half height cards tend
> to have mounting holes in the same places, so maybe find another half
> height card with a full height bracket, and steal the bracket?
> On Thu, Dec 22, 2016 at 11:31 AM, Romain Dolbeau <romain at dolbeau.org>
> > 2016-12-22 16:50 GMT+01:00 Francois Dion <francois.dion at gmail.com>:
> > > Perhaps there's an easy to find full height bracket that is close to
> > these
> > > measurements?
> > Perhaps you could 3D print one if you have all the measurement ? I had
> > an identical problem with an Infiniband HCA at home, and someone had
> > posted a 3D model on the Mellanox forum. I added some lenghtwise
> > reinforcement to the 3D model, printed it in some plastic stiffer than
> > PLA (can't remember the name ATM), and it has served me well for a
> > couple of years now despite the heavy cable.
> > Cordially,
> > --
> > Romain Dolbeau
> > _______________________________________________
> > rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
raspberry-python.blogspot.com - www.pyptug.org - www.3DFutureTech.info -
More information about the rescue