[rescue] Sun 4/110 mainboard ejector?
josh at imagestream.com
Fri Sep 18 13:04:23 CDT 2015
I was thinking about this more, Shapeways.com also prints in stainless
steel. If we had a good model we could get them to print a few. It's
$6 per part and $5 per cubic cm. Just a thought.
ISis ImageStream Internet Solutions, Inc.
4374 FM 1518, Selma, TX 78154, USA
Ph. +1-210-569-1211 Ext. 104
Josh at ImageStream.com
On 9/17/15 4:41 PM, rjtoegel wrote:
> MIT has one that prints in glass. Won't be long now.
> Dave McGuire <mcguire at neurotica.com> wrote:
>> On 09/17/2015 05:16 PM, Mike Meredith wrote:
>>>> I have somewhat of a too-intimate knowledge of how the Sun VME
>>>> ejectors behave. I'm quite certain neither an ABS nor a PLA printed
>>>> part will withstand that much pressure.
>>> However I suspect that a titanium printed part might hold up for a
>> My 3D printer doesn't print in titanium...does yours? ;) (if so, can
>> I send you some files? ;))
>> Dave McGuire, AK4HZ
>> New Kensington, PA
>> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
More information about the rescue