[rescue] Need BeBox front & IO Card

Scott Newell newell at cei.net
Thu May 29 21:46:06 CDT 2008

At 09:13 PM 5/29/2008, Joshua Boyd wrote:

>When I was asking about the process when work was looking into making
>some plastic I was told it would cost tens of thousands of dollars
>for tooling, but the parts themselves would be dirt cheap after that.

Nah, you can do it for mere thousands (low-end), if you don't need 
hard tooling.

For the BeBox replacement part, casting sounds like the place to start.


More information about the rescue mailing list