[rescue] Question of how to "smooth" power from Laser printer
Michael C. Vergallen
mvergall at telenet.be
Fri Mar 28 16:12:21 CDT 2008
-----BEGIN PGP SIGNED MESSAGE-----
Andrew Weiss wrote:
| On Mar 28, 2008, at 1:52 PM, Sridhar Ayengar wrote:
|> Phil Stracchino wrote:
|>>> " Ooh. I *like* that idea. Probably both stiffer and cheaper than
|>>> the " 3/4"-1" plywood I was considering for my desk rebuild, too.
|>>> hollow core doors are very strong too.
|>> But not in compression through the plane.
|> I was seriously considering making a desk out of lightweight concrete.
|> More for aesthetic purposes, but I'd bet it would be pretty strong.
|> Peace... Sridhar
| Wouldn't a desk need to have high tensile strength? Concrete is good
| under compression but not tension. Would you be intending to put rebar
| in the desk?
Just an idea if you build one from concrete I hope you do not need to
move the desk very far. I used 1 inch thick pressed board with wood
vinear ( like they use for kitchen counters ) for mine just had 2 of
them joined back to back to have enough dept.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v2.0.7 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
-----END PGP SIGNATURE-----
More information about the rescue