[rescue] Password reset on SMC TigerSwitch 8624T

Phil Brutsche phil at tux.obix.com
Sat Jun 2 23:06:27 CDT 2007

Devin Ganger wrote:
> Anyone here know any tricks? I can always opt for the "return to SMC" route,
> and since it's a new acquisition it's not like I'm depending on it for any
> sort of networking. Still, I'd rather take a few minutes to tweak it and get
> it running.

Depending on if it is a V1 or V2 unit "return to SMC" may be the
*official* solution.

In the manual it shows that you can reset the unit to factory defaults
over the serial port, have you tried that (you didn't explicitly say...)?


It's listed under "upgrading firmware via the serial port".


Phil Brutsche
phil at tux.obix.com

More information about the rescue mailing list