[rescue] Dual head Octane SI + ESI

Jochen Kunz jkunz at unixag-kl.fh-kl.de
Mon Sep 29 03:40:42 CDT 2003

On 2003.09.29 08:49 Bjorn Ramqvist wrote:

> AAAAA! *head explodes*
Boooom. ;-) 

But it seams that I have screwed up the GFX boards / Xserver. I played
around with different resolutions and refresh rates. I can't get the
secondary display to use 1280x1024_76 Hz. It always uses 71 Hz when I
choose the 1280x1024_76 mode. All 3D stuff doesn't work on the secondary
display. I.e. when I start "powerflip" I get an empty window. When I
move the window to the primary display all is well. When I start
"ImageView" on the secondary display the Xserver crashes... At least
"powerflip" worked on the secondary display after the installation. 

> hinv -m?
      PM10300MHZ Board: barcode KLB327     part 030-1355-001 rev  M
            IP30 Board: barcode KKR047     part 030-1467-001 rev  D
             FP1 Board: barcode KBT780     part 030-0891-003 rev  G
    PWR.SPPLY.ER Board: barcode AAE0100215 part 060-0035-002 rev  A
           MOT10 Board: barcode KGR298     part 030-1241-002 rev  J
            GM10 Board: barcode GAK372     part 030-0938-003 rev  T
1 300 MHZ IP30 Processor
CPU: MIPS R12000 Processor Chip Revision: 2.3
FPU: MIPS R12010 Floating Point Chip Revision: 0.0
Main memory size: 2048 Mbytes
Xbow ASIC: Revision 1.4
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 2 Mbytes
Integral SCSI controller 0: Version QL1040B (rev. 2), single ended
  Disk drive: unit 1 on SCSI controller 0
  Disk drive: unit 2 on SCSI controller 0
  Disk drive: unit 3 on SCSI controller 0
Integral SCSI controller 1: Version QL1040B (rev. 2), single ended
IOC3/IOC4 serial port: tty1
IOC3/IOC4 serial port: tty2
IOC3 parallel port: plp1
Graphics board: ESI
Graphics board: SI
Integral Fast Ethernet: ef0, version 1, pci 2
Iris Audio Processor: version RAD revision 12.0, number 1

I checked the board revisions. This is basicly an Octane2 with ESI GFX
instaed of VPro. 

BTW: Thanks to Kurt Huhn for his light bar repair page. My light bar is
now shining in bright blue. :-) 


Homepage: http://www.unixag-kl.fh-kl.de/~jkunz/

More information about the rescue mailing list