[rescue] Fibre Channel

Joshua D Boyd jdboyd at cs.millersville.edu
Thu Dec 26 16:35:49 CST 2002

On Thu, Dec 26, 2002 at 05:02:41PM -0500, Paul M. Hortiatis wrote:
> I recently got a few segate fibre channel drives. I have been looking
> around online and found where i can get the SCA plugs that will mate to
> the drive rather inexpensively, i want to make the "T" card adapters to
> use the drives in a loop with the controler, i wanted to know if any
> one here had done this, and if there was any thing special needed, like
> resistor and the like to set the drive id through the SCA on the drive.
> I have all the pinouts for the SCA from segates website.

Dave McGuire, a list member, has a project underway to make these
cards.  Search the archive for his email address and ask him.

Joshua D. Boyd

More information about the rescue mailing list