[rescue] SparcStation Voyager - hard drive
rescue at sunhelp.org
Mon Dec 3 14:32:04 CST 2001
The external connector is 50 pin. The internal connector is a 44 pin cable. the
hard disk you need is a 2.5" format SCSI drive. The drive is not so hard to
find. the mounting plate and cable will be lots of fun.
I have built at least 6 Voyager's out of parts and broken machines so this I
can speak with authorita on :)
On Mon, 03 Dec 2001, you wrote:
> The docs I have been able to find say that it is a 50 pin
> connector. Is it a standard 50 pin connector or were
> these drives made special for the Voyager?
> I can probably make a bracket, and it appears that Sun
> still sells the cables, so the only hard part I can see
> is locating a drive.
> > On Mon, 03 Dec 2001, you wrote:
> > > Third question (and last for now :-) It has no hard drive (probably
> > > because it was set up to be an Xterm and attempts to boot off the net.)
> > > I have a 411 box connected to it at the moment but would like to make
> > > this a little bit more portable by getting an internal drive for it.
> > > Anyone have a 2.5" SCSI drive & bracket & SCSI cable for a Voyager?
> > Good luck. Those bits are unobtanium unless you get lucky and find another
> > whole Voyager.
> > Mike N
> > _______________________________________________
> > rescue maillist - rescue at sunhelp.org
> > http://www.sunhelp.org/mailman/listinfo/rescue
> rescue maillist - rescue at sunhelp.org
More information about the rescue